How to Fit Your ResMed AirFit F20 for Maximum Comfort

How to Fit Your ResMed AirFit F20 for Maximum Comfort

How to Fit Your ResMed AirFit F20 for Maximum Comfort

A poorly fitted CPAP mask can cause discomfort, air leaks, and restless nights. The ResMed AirFit F20 Full Face Mask is designed with advanced features like the InfinitySeal™ cushion and magnetic headgear clips, but to get the most out of it, you need to know how to fit it properly.

Whether you’re new to CPAP therapy or upgrading your mask, here’s a step-by-step fitting guide to help you achieve the perfect balance of comfort and performance.

1. Start with the Right Size

Before you even put the mask on, ensure you’re using the correct size cushion (Small, Medium, or Large). ResMed provides a printable sizing guide to measure the bridge of your nose to under your lower lip.

Tip: A mask that’s too small may pinch or cause pressure marks, while one that’s too large can lead to constant air leaks.

2. Assemble and Check the Mask

Make sure all parts — the frame, cushion, headgear, magnetic clips, and elbow — are properly attached. A quick inspection will save you time later and ensure optimal performance.

3. Position the Mask on Your Face

  • Hold the mask cushion over your nose and mouth.
  • The top of the cushion should rest comfortably on the bridge of your nose, while the bottom seals under your lower lip.
  • Keep your head in a natural sleeping position (not tilted up or down).

4. Adjust the Headgear Straps

  • Pull the headgear over your head and secure the magnetic clips to the frame.
  • Start by adjusting the upper straps evenly, then the lower straps.
  • Aim for a snug fit — the cushion should rest gently against your skin, not pressed hard.

5. Connect the Mask to Your CPAP Machine

  • Attach the air tubing to the elbow connector.
  • Turn on your CPAP machine while lying down in your normal sleeping position.
  • This helps the cushion inflate and seal naturally.

6. Fine-Tune for Comfort

  1. If you feel air leaks near the eyes or mouth, gently readjust the straps — avoid overtightening.
  2. For persistent leaks, lift the mask slightly away from your face, let the cushion re-inflate, then reposition.

7. Test Different Sleep Positions

Roll onto your side, back, and any other preferred positions to ensure the seal remains consistent. The AirFit F20 is designed to stay secure even for active sleepers.

8. Check Daily and Maintain Weekly

  • Daily: Inspect straps and cushion for wear.
  • Weekly: Hand-wash the headgear and cushion in warm, soapy water.
  • Replace parts as recommended (cushion every month, headgear every 6 months) for best performance.

Pro Comfort Tips

  • Loosen the straps slightly before bed and re-secure them after lying down.
  • Use a CPAP-friendly pillow to reduce pressure on the mask.
  • Keep skin clean and oil-free before wearing the mask to improve the seal.

Final Thoughts

The ResMed AirFit F20 is engineered for comfort, but the perfect fit is the key to unlocking its full potential. By following these steps and maintaining your mask regularly, you’ll enjoy more restful nights, fewer leaks, and improved CPAP therapy results.

A few minutes spent adjusting your mask before bed can make the difference between a restless night and waking up refreshed.

Back to blog